Preparation:

1) All glass, chrome, carpet and lights must be removed for safety.

2) Vehicles must remain STOCK as from the factory.

3) Bumpers must be STOCK as from the factory.

4) Stock battery only. Battery may be re-located to the passenger floor or seat, securely fastened, or you may leave it in stock location and spray foam may be used around the battery.

5) The fuel tank must be removed from the stock area to behind the driver’s seat. You may use a boat tank, a fuel cell or the original stock tank. The fuel tank must be securely fastened and well covered. If the fuel tank is in front of the axle, you do NOT need to relocate it.

6) All doors may be wired or chained in 6 places per seam.

7) Trunks, hoods and tailgates may be wired or chained in 6 places, sheet metal to sheet metal. No wires or chains may be attached to the frame or bumpers. If you remove the trunk or tailgate, you lose that wire or chain.

8) A bar may be added behind the driver’s seat, attached from post to post.

9) Driver’s door may be reinforced.

10) DOT tires only. Tubes may be used. No filling tire with any material.

11) Rims must be steel. NO ALUMINUM RIMS.